Gargoyle Forum

I upgraded my 1043ND v1 from 1.7.0 to 1.7.1 with preserve settings, after reboot the router led indicates - POWER and a link to my laptop, no SYS.
No IP assingned to my laptop, no ping to the router. Any ideas?
Thanks for your help.

Hi to get in to failsafe on mine witch is a v2.1 i needed to plug my ethernet cable in to the wan port. Then i used putty to do a firstboot.

http://wiki.openwrt.org/doc/howto/generic.failsafe

I pluged the cable to WAN port, but no luck to enter the failsafe mode

michelin wrote:I pluged the cable to WAN port, but no luck to enter the failsafe mode

Power up your router. When the 'SYS' LED starts to blink, press the QSS push button repeatedly until the blinking of 'SYS' LED gets faster. Done = You
made OpenWrt boot into OpenWrt failsafe mode. Proceed with
In OpenWrt Failsafe Mode
http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd

I wrote in the 1st post - no SYS led blinking, only POWER and link if connected.

michelin wrote:I wrote in the 1st post - no SYS led blinking, only POWER and link if connected.

If failsafe does not work, the only way to fix it is via serial.

Read the Debricking section.
http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd

Already fixed. I do not recommend preserve settings.

michelin wrote:Already fixed. I do not recommend preserve settings.

known problem

How did you fix?

Thanks

VIA serial - telnet

[quote="tapper"]Hi to get in to failsafe on mine witch is a v2.1 i needed to plug my ethernet cable in to the wan port. Then i used putty to do a firstboot.

referring to ur rig, i just want to confirm that the TL-WR1043ND 'V2' will take the current release of gargoyle (table stipulates 1.x)

thx, jlw.