Gargoyle Forum

Hello i have a problem with your firmware i install gargoyle and is very good and stable but i has a problem with wireleas internet sometime its happen only if i change someting in the setting on 192.168.1.1 when. I change i cant do connect to the internet on wifi if i use cable rj45 i have internet but on wifi i cant it tell me windows cannot to connect to the network and also with other device so why it happen? First i install 1.6 from orginal tp link firmware and its was this bug and after i update to 1.7 and the bug is still ao what i am doing? Sorrt about my english i hope that you understand me thanks for the help

Wi-Fi is stable on my TP-Link TL-WR1043N/ND v2 with Gargoyle Version:1.7.X (Built 20150207-0832 git@3344fb7); and also previously with Gargoyle 1.6.2.

I have attached screenshots from Connection-Basic & Connection DHCP

does this help?

nworbnhoj wrote:Wi-Fi is stable on my TP-Link TL-WR1043N/ND v2 with Gargoyle Version:1.7.X (Built 20150207-0832 git@3344fb7); and also previously with Gargoyle 1.6.2.

I have attached screenshots from Connection-Basic & Connection DHCP

does this help?

i figure out what happen first when i change in the setting someting so i dont have an internet about 1 minute mybe 2 and then it work without touching someting but its still sucks they need to fix this problem and 2 i see that one computer tell me the windows cannot connect to the network and the fix is change channel so they need to fix the first problem i write to make me huppy how can i write to the manager or the gargoyle dev?

Gargoyle is built and maintained by volunteers who read posts to this forum.

However, if you are changing the Router IP address of your internet gateway and wanting the other computers on your LAN to reconfigure more quickly, then I think that you will need to write to some other higher authority.