Page 1 of 2
I didn't define the router good
Posted: Mon Dec 08, 2014 10:50 am
by ChaoscripT
Hi,
I have TP-Link WDr4300,
I had installed Gagoyle firmware,
It works good.
Now after I logged in in 192.168.1.1,
I wanted to make it repeater, so I did like in this picture,
http://www.gargoyle-router.com/wiki/lib ... bridge.jpg
But in "AP/Gateway IP" instead of 192.168.1.1, I put 192.168.0.1,
Now I can't login to the router, what can I do please?
Regards.
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 2:10 pm
by jimasek
You have to enter IP address and mask from 192.168.0.0/24 subnet (for example 192.168.0.101 and 255.255.255.0
Then you can login on the router by 192.168.0.1 IP address
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 2:38 pm
by ChaoscripT
Hi,
Thanks for reply,
I can't even access the TP-link 4300.
Regard.s
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 2:47 pm
by jimasek
You need to restore factory defaults and reconfigure the router
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 2:48 pm
by ChaoscripT
But how ?
I can't find the router on net.
Regards.
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 2:57 pm
by jimasek
Press and keep button Reset for 15 sec.
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 3:21 pm
by ChaoscripT
Made few times reset,
But now I can't even view this router.
I connect it to Modem, then connect to computer, it's not connect, and I can't login on 192.168.0.1
Regards.
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 5:01 pm
by jimasek
Default IP address in Gargoyle is 192.168.1.1
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 5:06 pm
by ChaoscripT
After factory reset, it's back to tp-link firmware no ?
Regards.
Re: I didn't define the router good
Posted: Mon Dec 08, 2014 5:11 pm
by jimasek
After factory reset, it's back to tp-link firmware no ?
No, I told about default Gargoyle settings.
