Gargoyle Forum

Hi
I have a wndr3700V2 which has gargoyle 1.6 (I believe) installed and was working great.

I wanted to try using the router as a wireless bridge/repeater to extend my new ISP router, so I selected the 'wireless bridge/repeater' option under Connection > Basic > Device Configuration > Configure Device As:

I also changed the SSID name. I then saved the changes, and it initially was working fine. I then rebooted the router.

Once it rebooted, the new SSID is visible but I cannot connect to it, nor can I access the GUI to log in (by ip address 192.168.1.1) by connecting an ethernet cable from the router lan to my computer.

I'm not sure what went wrong or what to do here to fix this.
If anyone could please help me with this, that would be great.

Thanks!

you have to log on to the IP you gave to the bridge. EG 192.168.1.2

Thanks for your reply

I actually didn't change the default IP (192.168.1.1) when I switched it to wireless bridge/repeater and that IP doesnt work anymore when i try.

Does the IP default to anything after switching to wireless bridge/repeater?

Thanks

failsafe rest required?

i have a TL-WDR4300 with GARGOYLE 1.6.2 everytime i change the settings the router drops out and i have to turn it off and on and then its fine again




_______________________

www.freespidersolitaire.info

sajjad321 wrote:i have a TL-WDR4300 with GARGOYLE 1.6.2 everytime i change the settings the router drops out and i have to turn it off and on and then its fine again

try this build

http://www.gargoyle-router.com/phpbb/vi ... =14&t=6356

When upgrading don't preserve settings