Gargoyle Forum

Hi all

I had problems installing gargoyle on my TP-Link TL-WDR3600 V1

Even tried installing a serial cable without any luck

In the end I found this YouTube clip and it worked

https://www.youtube.com/watch?v=qMWxLyFOXN4

In summary

Using TP-Link GUI install OpenWRT factory image

Then using the Openwrt GUI install Gargoyle sysupgrade image

There are most likly better ways of doing this, but this worked for me

Do you know can we use factory image files from OpenWRT wiki to reflash back the gargoyle firmware to the stock TP-Link WDR3600 (if want to revert back to stock/or reflash other open firmware) or it use different image firmware? Thanks.