Page 1 of 1
openwrt (barrier breaker) to gargoyle
Posted: Fri Aug 01, 2014 8:34 am
by Xarxas
What i must do if i want to change firmware of WR1043ND V2 router from openwrt (barrier breaker) to gargoyle? Can i use sysupgrade and install it via openwrt web interface?? thx
Re: openwrt (barrier breaker) to gargoyle
Posted: Fri Aug 01, 2014 12:50 pm
by Xarxas
I must go to stock and than flash with garoyle? Or wait for new release based on barrier breaker and flash straight from openwrt? When will be new release out? THX
Re: openwrt (barrier breaker) to gargoyle
Posted: Fri Aug 01, 2014 7:05 pm
by pbix
You can flash the appropriate Gargoyle image from this site directly on top of your OpenWRT and go back just as easily.