How to use TFTP to flash a wrt54g
Posted: Sun Jun 29, 2014 3:32 pm
I have a WRT54g with Gargoyle that is stuck in boot mode. It appears that using TFTP is the only practical way to reflash this one since I cannot get to the setup menu. From the various support forums there are numerous suggestions but no details of the TFTP command structure. Nothing I have tried appears to work, so I must not be using the proper commands. I need to run TFTP from Linux, so there are some basic linux procedures to follow. I can activate terminal mode from the folder where the Gargoyle firmware is stored and ping and connect to the router at 192.168.1.1, but I can not execute any commands. There must be a tftp user guide posted somewhere. Any suggestions?