Page 1 of 1
Can't access Gargoyle after repeater/bridge mode
Posted: Fri May 02, 2014 12:38 am
by shinto
I was having internet problem and was playing around with the settings and switch on Gargoyle's wireless bridge/repeater mode and now I can't even access my router. I tried resetting and power cycling a few times to no avail. How do I switch it back?
Router: TP-Link n750
Re: Can't access Gargoyle after repeater/bridge mode
Posted: Mon May 05, 2014 1:22 pm
by pbix
If you cannot remember the IP address you set for the bridge then you should use the recover mode to run 'firstboot" and restore the default settings. See the Wiki.
Re: Can't access Gargoyle after repeater/bridge mode
Posted: Sun Jun 15, 2014 9:31 pm
by d0u6
I too just goofed up on this..
Router reports;
Connection-specific DNS Suffix . :
Link-local IPv6 Address . . . . . : fe80::a8b5:b56d:51e3:f5e3%2
Autoconfiguration IPv4 Address. . : 169.254.245.227
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :
Without having a default gateway I can't even go into failsafe.. or atleast its not letting me. Is there anything I can do to resolve this?
Re: Can't access Gargoyle after repeater/bridge mode
Posted: Mon Jun 30, 2014 10:07 pm
by StopSpazzing
The topic you posted in is from 2009, and has already been answered. So I don't see why you posted.