Gargoyle Forum

Hi all, my first post.

I've recently opted for a TP-Link WDR4300, wanting to use Gargoyle for quota management. Before ordering the unit, I checked the Gargoyle site and although it wasn't listed in the documentation, there was a factory image available in the download area.

After I received the unit, on the box bar code, it turns out to be hardware version V1.7 which is not supported by Attitude Adjustment 12.09. So I've had to flash trunk Barrier Breaker, which seems to be running OK, at least on default settings. I haven't pushed it too far yet.

I thought I should be able to install Gargoyle using the packages. I'd like to get 1.6.0 up and running. What URL should I use in the opkg.conf to do this? The documentation says: but that looks out of date to me and I haven't been able to browse the download tree under: (says 403 forbidden)

TIA

I understanding it can no longer be done

You might have more luck building your own image against BB

Hi ispyisail
i was thinking the same thing as the op. I have a e3000 i wood like to run Gargoyle on can you even role Gargoyle against bb yet? @kahlcy
have you seen this thread? https://forum.openwrt.org/viewtopic.php?id=47382
Mite be something to play with until you can get Gargoyle.

Thanks tapper...I'll have a look.

I ended up flashing Gargoyle V1.6 without any issues for me on my V1.7 WDR4300.

See some more notes at:
http://www.gargoyle-router.com/phpbb/vi ... 373#p23373

kahlcy: gargoyle-router.com/packages/gargoyle-1.6/ar71xx/SUBTARGET/ depending on whether your subtarget is default, usb or usb_large is the correct path, but you can't browse the directory. The list of packages is in gargoyle-router.com/packages/gargoyle-1.6/ar71xx/SUBTARGET/Packages.gz, and that tells the package system what packages are available. If you're unsure about your subtarget, ssh into your router and it should be listed on the welcome banner, e.g. ar71xx / SUBTARGET.

fantastic, thanks eric, great project BTW....