Gargoyle Forum

Hi, I have the latest version installed on a WRT54GS. I have 4 different bandwidth quotas set up and they seem to be working fine.

A couple weeks ago, my router froze and I had to power cycle to bring it back online. Since then, the Firewall\Quotas page does not show any active quotas, I can see the Status\Quota Usage just fine but since I can't see the active quotas, I can't edit them.

Is there any way I can bring them back or do I need to wipe the firmware, reinstall and recreate them?


thx

Jeff

I have just struck the same problem tonight.

I installed the Gargoyle in a friends share house and was remotely adding restrictions as somebody had worked out that using a static ip address outside the range I gave them using DHCP. I set restrictions of 0 MB every hour for uploads and downloads for ip ranges ie 192.168.1.2-192.168.1.99, 192.168.1.105-192.168.1.254, saved and can now not see ANY quotas.

I can't get access to the house without major hassles.

Any suggestions?

-Gary

This is a duplicate of the bug reported here. Please see my response in that thread.