How to enable AES encryption
Posted: Sat Mar 08, 2014 10:45 pm
Hi I am new to this forum. I just registered because I had installed 1.6.0 firmware on my router TP Link TL WR1043ND V1.0.
I had no problem to change the original firmware by following the instructions.
The only problem I have is that I can't find the encryption WAP2 AES to use the router in wireless N.
The speed is 130.0 Mbit / s (-38 dBm) and I understand that must be encrypted as WAP2 AES for the router to operate in mode N.
I searched the forum and it seems that the speed problem in wireless mode is a complex issue.
Thank you very much.
The English is not my native language.
I had no problem to change the original firmware by following the instructions.
The only problem I have is that I can't find the encryption WAP2 AES to use the router in wireless N.
The speed is 130.0 Mbit / s (-38 dBm) and I understand that must be encrypted as WAP2 AES for the router to operate in mode N.
I searched the forum and it seems that the speed problem in wireless mode is a complex issue.
Thank you very much.
The English is not my native language.