Activated QoS and removed rules. Can't access anything.
Posted: Sat Jan 04, 2014 10:09 pm
Hi,
I own a NETGEAR WGT634U. I flashed gargoyle_1.5.11-wgt634u-squashfs.bin on it and got it to work.
Then I started looking at the QoS things. And since I wanted to limit the bandwidth of *everything* that went through that router, I activated QoS and removed all the classification rules and all the service classes... I also remember setting the default service class to "normal". Anyway, I can't access my router from http/https/ssh/telnet...
Hopping something would still be open, I nmaped it. A "normal" nmap told me it seemed down because it blocked ping probes and asked me to try -Pn. With -Pn, it told me it was up (with 0.12s latency) but that all 1000 scanned ports are filtered.
Then I thought "whatever, I'll hard reset it". But unfortunately, that didn't work... Or maybe I didn't use the right timings but the timing that worked before I flashed Gargoyle didn't work and 30s-reboot-30s didn't work either. Then, looking at forums, I saw someone speaking of spamming the button during boot. So I did that and it make the power led's luminosity cycle: high, low, high and so on. But it didn't look like it changed anything else.
So I'd really like it if someone could tell me how to unbrick it without needing a serial. And if it's not possible then would this cable work? ( http://www.amazon.fr/Arduino-Cables-DEV ... +FTDI+3.3V )
Thank you in advance.
I own a NETGEAR WGT634U. I flashed gargoyle_1.5.11-wgt634u-squashfs.bin on it and got it to work.
Then I started looking at the QoS things. And since I wanted to limit the bandwidth of *everything* that went through that router, I activated QoS and removed all the classification rules and all the service classes... I also remember setting the default service class to "normal". Anyway, I can't access my router from http/https/ssh/telnet...
Hopping something would still be open, I nmaped it. A "normal" nmap told me it seemed down because it blocked ping probes and asked me to try -Pn. With -Pn, it told me it was up (with 0.12s latency) but that all 1000 scanned ports are filtered.
Then I thought "whatever, I'll hard reset it". But unfortunately, that didn't work... Or maybe I didn't use the right timings but the timing that worked before I flashed Gargoyle didn't work and 30s-reboot-30s didn't work either. Then, looking at forums, I saw someone speaking of spamming the button during boot. So I did that and it make the power led's luminosity cycle: high, low, high and so on. But it didn't look like it changed anything else.
So I'd really like it if someone could tell me how to unbrick it without needing a serial. And if it's not possible then would this cable work? ( http://www.amazon.fr/Arduino-Cables-DEV ... +FTDI+3.3V )
Thank you in advance.