Page 1 of 1
Which OpenWRT is Gargoyle using?
Posted: Wed Jan 20, 2010 7:18 am
by Mouse
Hi all,
I am thinking of installing on my WRT54G v2 Gargoyle, updating from directly OpenWRT using the Gargoyle .trx image. Since OpenWRT just released a new version, I was wondering on which OpenWRT Kamikaze version Gargoyle is based?
Could you point me to any hints?
Regards
Mouse
Re: Which OpenWRT is Gargoyle using?
Posted: Wed Jan 20, 2010 9:19 am
by DoesItMatter
Gargoyle uses the latest stable build.
That being said, if a new one was just released, Gargoyle may
be using that in new releases, but none of the existing builds
are using it.
If I remember right, its using the stable 8.09 Kamikaze.
I'm sure Eric will pipe in with the tech part.
I never got into compiling the buidls myself.
I just try to install, test, and break stuff!
Re: Which OpenWRT is Gargoyle using?
Posted: Tue Jan 26, 2010 9:39 am
by Eric
Right now it's based on a version in between 8.09.1 and 8.09.2, specifically trunk svn revision 17855 in the 8.09 branch.
I haven't been updating the revision regularly because in the past changes upstream have broken things unexpectedly. However, now that 8.09.2 is out (which is an official release) I will likely bump the revision in the near future.
Re: Which OpenWRT is Gargoyle using?
Posted: Sun Jan 31, 2010 2:41 pm
by Gargoyle87
Will the Linksys WRT610N be supported by Gargoyle after updating the revision?
Re: Which OpenWRT is Gargoyle using?
Posted: Mon Feb 01, 2010 8:47 am
by Eric
It won't be officially supported -- I don't own one of these, and as far as I can tell even in the latest openwrt (8.09.2) support for this is limited.
However, if you want to try it/play with it/help get it working, any and all suggestions and/or contributions would be most welcome.