[Irrelevant] Keep AP Settings After Disabling
Posted: Thu Nov 14, 2013 12:43 pm
Hello all,
I've recently purchased a TP-Link TL-WR1043ND (1.11) router and since default firmware blocked google (nice job, TP-Link...
), It wasn't long before I switched to Gargoyle.
Most of the time my wireless is off, but from time to time I need to enable it - problem is, I need to enter wireless settings (SSID, password etc.) from scratch each time.
Is there a way to keep settings so I can only enable/disable wireless on demand?
Thanks, Adam.
* EDIT *
I haven't tried again, as I now use my Wifi continuously.
I've recently purchased a TP-Link TL-WR1043ND (1.11) router and since default firmware blocked google (nice job, TP-Link...
), It wasn't long before I switched to Gargoyle.Most of the time my wireless is off, but from time to time I need to enable it - problem is, I need to enter wireless settings (SSID, password etc.) from scratch each time.
Is there a way to keep settings so I can only enable/disable wireless on demand?
Thanks, Adam.
* EDIT *
I haven't tried again, as I now use my Wifi continuously.