Page 1 of 1
Custom firmware for WCR-HP-G300? Who can help me?
Posted: Mon Oct 28, 2013 11:18 am
by popbob
The WCR-HP-G300 is powered by a Ralink RT3352 SoC 802.11b/g/n 2T2R WLAN System on a Chip (SoC). It also has Macronix MX25L3206EM2I-12G 16MB RAM and Macronix MX25L3205D 4MB Flash.
http://vr-zone.com/articles/buffalo-wcr ... 16336.html
Please help me how to install Gargoyle firmware.
Thanks,
Re: Custom firmware for WCR-HP-G300? Who can help me?
Posted: Mon Oct 28, 2013 2:00 pm
by ispyisail
Re: Custom firmware for WCR-HP-G300? Who can help me?
Posted: Wed Oct 30, 2013 8:16 am
by popbob
but it's not wCr-hp-g300
Re: Custom firmware for WCR-HP-G300? Who can help me?
Posted: Wed Oct 30, 2013 9:57 am
by fox85
Just 16MB RAM would be a problem that runs with openwrt.
Re: Custom firmware for WCR-HP-G300? Who can help me?
Posted: Wed Oct 30, 2013 11:43 am
by pbix
With only 16MB of RAM and 4MB of flash this router will never run Gargoyle.
Re: Custom firmware for WCR-HP-G300? Who can help me?
Posted: Thu Oct 31, 2013 6:15 am
by popbob
hic