Red Light! WZR-600DHP
Posted: Wed Sep 18, 2013 7:57 pm
So I was able to successfully flash my Buffalo WZR-600DHP router using the files from OPENWRT link:
wiki.openwrt.org/toh/buffalo/wzr-600dhp
I installed this file through telnet: http://downloads.openwrt.org/attitude_a ... pgrade.bin
I was able to open a browser and verify the installation. On to installing Gargoyle. This is where it took a down turn
I installed using the flash option through OPENWRT and used file :
gargoyle_1.5.10-ar71xx-generic-wzr-hp-ag300h-squashfs-factory.bin
It started to install and now I cannot ssh/telnet or access gui
The only lights on are the power light and a constant RED light. I have not restarted the router yet - I am suspect because I had another similar file 300n which I might have download on accident but I don't think I did. IDK.
I need a recover plan - any help?
wiki.openwrt.org/toh/buffalo/wzr-600dhp
I installed this file through telnet: http://downloads.openwrt.org/attitude_a ... pgrade.bin
I was able to open a browser and verify the installation. On to installing Gargoyle. This is where it took a down turn
I installed using the flash option through OPENWRT and used file :
gargoyle_1.5.10-ar71xx-generic-wzr-hp-ag300h-squashfs-factory.bin
It started to install and now I cannot ssh/telnet or access gui
The only lights on are the power light and a constant RED light. I have not restarted the router yet - I am suspect because I had another similar file 300n which I might have download on accident but I don't think I did. IDK.
I need a recover plan - any help?