WR941ND version 3.8
Posted: Fri Aug 23, 2013 2:50 am
Has anyone had any luck with this version. I've got a WR941ND v 3.6 working quiet happily with Open-Wrt with Gargoyle on top but managed to brick a V3.8 version.
I know there were some issues with the h/w v3.2 flash chip not being writeable, but can't find anything online about anyone with any experience with Gargoyle, Open-wrt, DD-wrt, or anything else on a v3.8 version
Strange thing is it is totally bricked, in that I can't even get any response from a serial cable. Note even to u-boot, and I'm quiet experienced about wiring on a serial cable, making sure the pins under the TX pin are shorted and so on. I'm not even getting 3.3v between the TX pin and GND implying a hardware problem, but the only thing I did from brand new was to try installing the firmware (gargoyle 1.5.10) and it is difficult to see how this could cause a hardware fault.
Any help gratefully received, have also posted in the open-wrt forum
I know there were some issues with the h/w v3.2 flash chip not being writeable, but can't find anything online about anyone with any experience with Gargoyle, Open-wrt, DD-wrt, or anything else on a v3.8 version
Strange thing is it is totally bricked, in that I can't even get any response from a serial cable. Note even to u-boot, and I'm quiet experienced about wiring on a serial cable, making sure the pins under the TX pin are shorted and so on. I'm not even getting 3.3v between the TX pin and GND implying a hardware problem, but the only thing I did from brand new was to try installing the firmware (gargoyle 1.5.10) and it is difficult to see how this could cause a hardware fault.
Any help gratefully received, have also posted in the open-wrt forum