Page 1 of 1
Gargoyle on Buffalo WBMR-HP-G300H
Posted: Thu Aug 08, 2013 2:28 am
by moltenice
Hello, I currently have a Buffalo WBMR-HP-G300H flashed to dd-wrt v24-sp2 running and would like to switch to Gargoyle.
I've tried looking everywhere but am still unclear whether Gargoyle is supported on this model.
Could anyone advice?
Thanks!
Re: Gargoyle on Buffalo WBMR-HP-G300H
Posted: Sat Aug 10, 2013 4:11 am
by DoesItMatter
http://wiki.openwrt.org/toh/buffalo/wbmr-hp-g300h
Read up on it
Looks like it might be a one-way trip if you go to OpenWRT/Gargoyle
Also, this one seems much trickier for flashing
so make sure that you know/understand/can-do serial recovery!
Might have to wait for a newer Gargoyle release before you
see it supported by Gargoyle
You will probably have to compile your own OpenWRT images for it
Re: Gargoyle on Buffalo WBMR-HP-G300H
Posted: Tue Aug 13, 2013 12:21 pm
by moltenice
DoesItMatter wrote:http://wiki.openwrt.org/toh/buffalo/wbmr-hp-g300h
Read up on it
Looks like it might be a one-way trip if you go to OpenWRT/Gargoyle
Also, this one seems much trickier for flashing
so make sure that you know/understand/can-do serial recovery!
Might have to wait for a newer Gargoyle release before you
see it supported by Gargoyle
You will probably have to compile your own OpenWRT images for it
Hey, thanks a bunch! I think I'd rather just buy a new router that supports Gargoyle (probs the one you guys offer)
Re: Gargoyle on Buffalo WBMR-HP-G300H
Posted: Sun Apr 12, 2015 10:04 am
by ryanh
Hi
Sorry for the noob question...
My WBMR-HP-G300H has Gargoyle 1.5 experimental installed. Which file do I download from the downloads section to get 1.7.1 Experimental?
Thanks