Page 1 of 1
TP-Link WR842ND - install gargoyle is possible?
Posted: Thu Jun 13, 2013 4:08 pm
by Warlock
Guys, how do I install this gargoyle router? I still have the original firmware tp-link.
Re: TP-Link WR842ND - install gargoyle is possible?
Posted: Thu Jun 13, 2013 7:06 pm
by BashfulBladder
Get the firmware file from the download section.
If you don't know which (factory or sysupgrade), read the 'Atheros AR71XX Routers' section here:
http://www.gargoyle-router.com/wiki/dok ... ed_routers
You may have to shorten the firmware filename.
Re: TP-Link WR842ND - install gargoyle is possible?
Posted: Fri Jun 14, 2013 5:54 am
by Warlock
Ok, I did the upgrade procedure: I did the update with the factory and then the sysupgrade is running smoothly, thanks for the info. I only have one more question: how do I bandwich control? I want to make a control by ip range, like, I would use the ip xxx.xxx.xxx.1, from 2 to 254 would be limited to the speed down / up I chose, but do not know how to configure this in the gargoyle. I appreciate if you could help me.