Gargoyle Forum

Hello i have flashed Dir 300 with 1.1.2 gargoyle.
and almost everything is working beside WAN port
dir 300 dont want to get lease from cable modem
and aditionaly any changes and saves in connection setup
hang the router totally. is it common with that experimental ver?


is 1.0.14 working properly?


ps. 1.1.2 works well on my fonera.

regards
p1vo

Try the 1.0.14 version first and make sure to reset to defaults.

Power-cycle your cable modem as well and then see if the
DIR-300 will get an IP from the cablemodem

so - do this

1) Flash DIR 300 with 1.0.14

2) Reset to defaults and reboot DIR-300

3) With DIR-300 connected to cablemodem - power-cycle the
cable-modem and then check and see if the DIR-300 is getting
an IP address from your provider

4) Don't change any settings, just try and see if you can get 1 PC
working to internet and websites, etc.

If thats all working, then go ahead and start configuring.

thx its working perfectly on 1.0.14