Gargoyle Forum

Hello,

I have just flashed my wndr3700 V1 with Gargoyle and then configured my wireless connections. now when I connect my modem(DCM 475) , I do not get WAN IP on wndr3700.. hence no internet on any device connecting to router..I have already powercycled both and it didn't work.. any more suggestions?

Thanks,

Niraj

Also my link status led on modem does not lit up when i plug in my modem to router. Am i missing any step?

nirajshah7 wrote:Also my link status led on modem does not lit up when i plug in my modem to router. Am i missing any step?

Reverted back to Stock firmware and still WAN port was showing dead... It seems I must have made some mistake while flashing gargoyle.. is there any way to resolve this issue? Any help will really appreciated.

Thanks

BUMP... guys can anyone help ?

can anyone help me resolving the issue?

nirajshah7 wrote:

nirajshah7 wrote:Also my link status led on modem does not lit up when i plug in my modem to router. Am i missing any step?

Reverted back to Stock firmware and still WAN port was showing dead... It seems I must have made some mistake while flashing gargoyle.. is there any way to resolve this issue? Any help will really appreciated.

Thanks

Check your WAN interface configuration.
Doesn't sound like you did anything wrong though..

Was it working before you change the firmware?

Thanks for reply. yes it was working fine when I was on stock. I tried reverting back to stock it worked fine...

I've the same problem on WDR3600

It actually works if i place a switch between router and modem!!!

Did you reset the modem?