Gargoyle Forum

I have been unable to configure my Gargoyle to the Client+AP mode.

When setting up my wrt54gl v1.1 with gargoyle v1.4.7 I am running into a problem setting the wireless connection to "Client+AP". I only seeing the "client" option.

Under the Configuration screen I Have:

Configured Device as "Gateway (default)"

The internet/WAN connected via set to "DHCP wireless"
current IP "192.168.0.14"
Current lease expires "2/20/14 17:04 GMT"
WAN Ethernet port "Bridge to LAN"

Local Network LAN Router IP: "192.168.1.1"
Subnet Mask: "255.255.255.0"
Allow Alternate DNS: "Force Clients to use
Router DNS Service"

Wireless Wireless mode: "Client" - no option for Client+AP
Transmit Power: "Custom" "8"
Wireless MAC Filter: "Disabled"

SSID "HotSpot"
Wireless Channel "3"
Encryption "WPA2 PSK"
Password "********"

Can anyone help??

Flash back to an earlier version.

Backup your config so you can always go back to 1.4.7 later

Reset your router to defaults

Flash version 1.3.9 (last broadcom 2.4 series of drivers)

If it works there, then again, reset to defaults and flash back to 1.4.7

If the settings disappear, you need to go back to 1.3.9 and stick with it