Gargoyle Forum

Hi,
I bought an used wndr3700v1 and I installed Gargoyle 1.5.9

I have some doubts for the wifi:

- I cannot reach 300 Mbps, only 150 Mbps
- it is limited to 1-10 channel (not even the 11 channel);
- it is limited to 17dBm trasmission power.

I double checked it is selected 40MHz both router and wifi card (Intel 5100). There is only my wifi signal here, no interferences and in fact inssider shows me a 40MHz channel correctly. I was able to connect at near 300 Mbps with stock firmware.

I read about the regulatory.bin, but I really didn't understand how to make it. There is not a "for dummy" guide.

Can someone please help me? Thanks

I fixed the 300 Mbps issue. For future reference I had to change one settings:

Ad Hoc Qos mode: WMM enabled

Then pay attention if there is not traffic the wifi link is set to 150 Mbps and if you start to move data it goes up to 240-270 Mbps.

Waiting for a help with the channels and tx trasmit power...