Gargoyle Forum

Hi,

I am loving the firmware but have an odd issue. I have everything setup and working perfectly, but sometimes when I enter the management page, most of my port forwards are missing. They continue to work but at the next boot of the router, they no longer function and I must restore them from backup.

Anyone else ever see this?

Gargoyle Version:1.5.9
Model: NETGEAR NDR3700v2

Thanks!

I too have seen this happen a couple times. I'm using the same router and version of gargoyle as the OP. I did not preserve any settings and did a 30/30/30 reset before installing 1.5.9. I don't know of any fix for this, but I haven't seen it happen again lately, been about a week since it last happened. I'm just here to confirm that it could be an issue specific to the WNDR3700v2.

Xaruza, 2 weeks now, so is the problem still present after starting from scratch or gone completely? I'd rather not start over but will if it fixes this. Thanks.