Gargoyle Forum

Hi I just purchased à Buffalo G450H router.

Has anybody intalled Gargoyle 1.5.8 on it?

I received me router today and tried to install the factory bin file with the web interface. I got an unsuccesful message and nothing changed. Does anyone know if I Telnet on the router, do a wget of the file and a mtd will work? Like the instructions of wrz-hp-g300nh?

That didn't go to well. The DIAG light is flashing and I can't acces the router. I tried 192.168.1.1 and 192.168.1.1 with no response.

À serial to USB adapter is on it's way.

Before I try the serial interface, I want to try tftp to put a new firmware on the router. I tried all the solutions I could find relative to the wzr-hp-g450h. I also tried methods I found for the WZR-HP-G300NH2, but adapting them to the 450. Can anybody reply and give me some advice?

I also flashed yesterday G450h this firmware gargoyle_1.5.8-ar71xx-generic-wzr-hp-g450h-squashfs-factory.bin
Now blink Diag.
I will try to flash a Jtag.
To flash the router to use the firmware in binary format.
Here firmware dump in binary format for buffalo G450H.
http://narod.ru/disk/64578435001.4c72fa ... d.bin.html

I finally got to make my router running again. I used the serial interface and transferred via ymodem an openwrt frimware (the last version: attitude adjustment).

I still have some work to do because it seems that the wifi is offline every 2-3 minutes, and comes back online by itself.

I now also want to add the gargoyle packages, the documentation is based on the backfire version of openwrt. Can i use the same steps and the same packages with attitude adjustements, is there a ressource somewhere that I can read to help me?

I used the openwrt web interface to update the firmware. I sent the gargoyle sysupdate and got Gargoyle to run, finally!!!