Gargoyle Forum

A forum to discuss the Gargoyle web interface for Openwrt
https://www.gargoyle-router.com/phpbb/

1.5.8 941ND brick after reboot

https://www.gargoyle-router.com/phpbb/viewtopic.php?t=3432

Page 1 of 1

1.5.8 941ND brick after reboot

Posted: Wed Nov 14, 2012 8:35 am
by ttb
Install 1.5.8 firmware on 941ND 3.6. Reset settings via web. Then turn router in bridge mode, client+repeater. Input all IP adresses, SSID and passwords. Then click "save settings". Router reboots and... nothing.

Telnet (standart and failsafe), web, DHCP and ping don'work. All indicates work properly.

Re: 1.5.8 941ND brick after reboot

Posted: Thu Nov 15, 2012 5:09 am
by ispyisail
you might need to get a serial cable

Re: 1.5.8 941ND brick after reboot

Posted: Thu Nov 15, 2012 6:01 am
by ttb
ispyisail wrote:you might need to get a serial cable
Already. I flashed Gargoyle via serial and it's work fine now.

What firmware i must flash for back to stock? With _boot_ or _up_ in file name? OpenWRT Wiki says _boot_, other users say _up_. I have't found stock FW with _boot_ in file name.
Flash via serial or via web?
All times are UTC-04:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited