Gargoyle Forum

hello i was testing this firmware gargoyle_1.5.8-wrt54g-squashfs.bin
i have problem to connect me with lan , the power led lit and get suck after little minutes , i don t know how toget inside ssh , admin password
i have one error .
when led power stop to lit i can get inside web interface ...
after one time i can put mode client .but when i disconect my router the power lit again and i need to wait .
how to reset (nv ram clean)?
how to back from ddwrt ?
thank you

http://www.dd-wrt.com/wiki/index.php/Re ... _Bad_Flash

Use that for recovery - simplest on the WRT54G's

You can recover with DD-WRT firmware or Gargoyle or OpenWRT

For best stability on WRT54G's - try this one:

gargoyle_1.2.5-wrt54g-squashfs.bin

i can to get inside web interface when i try to upgrate it s dont working at all.
i try to get shh with putty ,admin and my password , tell acces denied ...
whay isthe way to get inside shh?
thank you to help me

i can find the way get inside ssh root and the password you choose before
now , i want to tftp to put back the firm ddwrt , it doesn t work ...
get ping and all ... i will try more with windows xp , may be with windows 7 may have problem ...

oki i revive this router with jtag now the client mode is working
but i cant have the mode client ap working
my ap is making but i dont have internet , coud you help me ?
i put that firm :gargoyle_1.2.5-wrt54g-squashfs.bin
thank you

Please try v 1.4.7.

oki i have the version 1.4.7 but the option to put like client ap don t appear in menu only client ...
the firmware look like better with power of signal wifi ...white light to show wifi working
get response more fast .
i need to put this router like client and make my ap please help me

Prior to v1.5.8 Gargoyle cannot be both a bridge/repeater and an AP. If this is what you want to do then you cannot achieve this with your router. Your router does not have enough RAM to run any version of Gargoyle after v1.5.6. Do not attempt to use v1.5.8 with your router.

I am not sure what you want to do so I am not sure if the above is important in your case or not. You should post a screen shot of your entire connection->basic page. And you should make a drawing or much better description of what you want to do and post it here.

Normally I would not respond to such a post as yours with so little information but I suspect English is not your first language so I am being more patient.

i want to make that :


thank you to have so much pacience with me !
this version 1.4.7 do not have this mode . just only client
my router is wrt54g v3
thank you

celica wrote:but the option to put like client ap don t appear in menu only client

The first line of your screen shows "client+AP'.

Why do you claim it does not appear? It is there.