WDS Config
Posted: Fri Aug 24, 2012 8:14 pm
Hi All
I'm setting up a WDS repeater, but not sure if it is correct.
My doubt is about the repetition of the wireless signal.
Apparently not realize improvements in signal intensity for more distant hosts.
My PC is 192.168.2.100 and connect fine to internet. Its connectes on Repeater lan via Ether cable.
Thanks for any help.
PS: Same hardware (TL MR3420)
Main firmware 1.5.6 (updated)
Repeater firmware 1.5.6 (factory install - first time install)
6 device screens:
I'm setting up a WDS repeater, but not sure if it is correct.
My doubt is about the repetition of the wireless signal.
Apparently not realize improvements in signal intensity for more distant hosts.
My PC is 192.168.2.100 and connect fine to internet. Its connectes on Repeater lan via Ether cable.
Thanks for any help.
PS: Same hardware (TL MR3420)
Main firmware 1.5.6 (updated)
Repeater firmware 1.5.6 (factory install - first time install)
6 device screens:
- MAIN CONNECTION BASIC
- main_conection_basic.jpg (190.04 KiB) Viewed 2522 times