Gargoyle Forum

sory i m not english.
after Upgrade Firmware gargoyles.bin.
the furst password was not password.

1. Install Wireshark on your computer.
2. Configure your computer with static IP 192.168.1.2
3. Connect your computer to a LAN port on the router.
4. Start Wireshark and monitor the LAN connection.
5. Powerup your router, when wireshark shows the first packet from 192.168.1.1 immediately press and hold the reset button on the back of the router for three seconds.
6. Router power LED should be flashing quickly. (Failsafe mode)
7. From a command prompt on your computer “telnet 192.168.1.1”
8. From the command prompt of the router “firstboot”
9. Reboot your router which should now come up in its default Gargoyle configuration.

thank you.

Start Wireshark and monitor the LAN connection.

Instead of using wireshaek why not use command line?

beceause i m not good with command line.
with gargoyle_1.5.6-ar71xx-tl-mr3420-v1-squashfs-sysupgrade.bin firmware i try again and y have the same problem.
password is not password.

3G is working with gargoyles?
i can t do it.
i try to do 3G with openwrt but it s too complicate for me.

3G is working with gargoyles?

yes but only some dongles

i have
-serra compass 889
-huawei e 169
with ariginal firmare the two dongles are recognized but upload is not working.
that why i m looking for an other firmware.

looks like you have a few issues

password and 3g

both work fine for me

we can explore both of these issues more if you want to put in a little work?

can you tell us router model and version

screen shots of any information really helps

welcome to command line

http://translate.google.com/translate?s ... F3g.mr3220

http://wiki.openwrt.org/es/doc/howto/3g.mr3220
i know but it s so dificult for me.
i read also http://wiki.openwrt.org/doc/recipes/3gdongle but i dont andurstant everything.

my router is tp-link tl-mr3420 ver:1.2

lets talk about your password problem

what browser are you using to connect with?

There have been some reported problems with firefox