Page 1 of 1
Revert TP-Link TL-WR1043ND to Stock?
Posted: Mon May 21, 2012 12:54 am
by lovelyjubbly
I'd like to revert my 1043 to stock firmware, as the Gargoyle interface is too slow and hangs most of the time.
I've tried the procedure below but the upgrade just hangs forever and stays on Gargoyle.
http://www.gargoyle-router.com/wiki/dok ... l_firmware
Any ideas?
Re: Revert TP-Link TL-WR1043ND to Stock?
Posted: Wed May 23, 2012 1:51 am
by lovelyjubbly
Anyone?
Re: Revert TP-Link TL-WR1043ND to Stock?
Posted: Thu May 24, 2012 10:47 pm
by pmerrill
Check out the Installation guide, there is a link to a bin file that has the stock firmware for 1043ND.
http://www.gargoyle-router.com/wiki/dok ... l-wr1043nd
Re: Revert TP-Link TL-WR1043ND to Stock?
Posted: Thu May 24, 2012 10:57 pm
by lovelyjubbly
Thanks Paul,
If you read my original post you'll see I've already tried that
Re: Revert TP-Link TL-WR1043ND to Stock?
Posted: Thu May 31, 2012 7:42 am
by IeU
I am having the same issue, it wont revert back. Is it safe/ok to use the bin file that is supplied to revert ddwrt back to stock?
I basicaly want to revert back bcse i got the "No Wan acccess" bug:
http://www.gargoyle-router.com/phpbb/vi ... f=8&t=2584
Which i suspect it just happens when u go to Gargoyle from the LATEST wr1043nd firmware. I beleive if you come from an older stock, this WAN bug wont appear . . .
Re: Revert TP-Link TL-WR1043ND to Stock?
Posted: Fri Feb 17, 2017 8:39 pm
by Batublock