Gargoyle Forum

Good afternoon. Starting with firmware 1.5.3 does not appear the window management USB drive when you connect it. Up to and including 1.5.2 everything was working correctly. In what may be the problem? We used the flash drives of different brands with different file systems and without them. A month ago, someone already wrote about a similar issue, but no one answered - was advised to just reset to default and reflash again.
I use TP-LINK 1043 v1.8.

petruha wrote:...
A month ago, someone already wrote about a similar issue, but no one answered - was advised to just reset to default and reflash again.
...

That is also the correct answer. But this time you should try to upgrade to 1.5.4 and try to check if it is working, before you try to restore the settings.

Of course, I waited until version 1.5.4. and only then written. The problem exists in 1.5.3 and 1.5.4
Resetting does not help. USB flash drive is mounted correctly - I see through winSCP mapped drive and can read the contents - the problem is displayed through the Gargoyles (

That could change with 1.5.2?

How have you setup USB storage in the beginning?
Has this been through the webinterface or have you done it through SSH?
What internet browser are you using?

For example, I updated the firmware to 1.5.4, reset the default, set up an internet connection, after reboot the router put the flash drive. Through access to SSH flash drive show the correct(through WinSCP). From Web browser - no (.
I've been using Google Chrome, Opera, Internet Explorer - http or https.

petruha wrote:For example, I updated the firmware to 1.5.4, reset the default, set up an internet connection, after reboot the router put the flash drive. Through access to SSH flash drive show the correct(through WinSCP). From Web browser - no (.
I've been using Google Chrome, Opera, Internet Explorer - http or https.

But haw have you setup the USB storage settings originally, was that through SSH or through the webinterface?

I can `t access the settings through a web interface.....
I'm just trying to set up access to the flash drive through a web interface, but there is no possibility to get (
By SSH I look at the way the file system / tmp / usb_mount / dev_sda

petruha wrote:I can `t access the settings through a web interface.....
I'm just trying to set up access to the flash drive through a web interface, but there is no possibility to get (
By SSH I look at the way the file system / tmp / usb_mount / dev_sda

I ask how you did when you did set it up originally, no how you access it now.

Sorry for my english) I from Ukraine.
USB Drive bought at the store, formatted in FAT32 and put in a router - it's all). I did not prepare it.
What do you mean "USB storage settings originally" ?