Page 1 of 1
Test Build? WNR2200
Posted: Sat Feb 25, 2012 7:27 pm
by ehren8879
The Netgear WNR2200 just recently got preliminary DD-WRT support. I was wondering if there's a vanilla version of Gargoyle available that I can try to flash on this router? This router has a recovery mode much like the WNDR3700.
Specs:
AR7241
64 MB RAM
8 MB SPI Flash
AR9287 2T2R PCIe
4 FE LAN, 1 FE WAN through AR7241 internal switch.
1xUSB 2.0
Re: Test Build? WNR2200
Posted: Sun Feb 26, 2012 9:42 am
by pbix
Gargoyle is based on OpenWRT and since I do not see support for the WNR2200 there it is not supported in Gargoyle. For questions about when or if it would be supported you should post over at openwrt.org.
Re: Test Build? WNR2200
Posted: Sun Feb 26, 2012 10:50 am
by ehren8879
Research indicates the WNR2200 firmware is a Netgear's modified version of kamikaze 7.09. Again, this is similar to the WNDR3700's which appears to natively run a fork of build 7.09.
Am I wrong to think the WNR2200 could therefore be supported? I'll pursue researching the development path over at openwrt.org. Thanks for the response!
Re: Test Build? WNR2200
Posted: Sun Feb 26, 2012 1:18 pm
by hnl_dk
ehren8879 wrote:Research indicates the WNR2200 firmware is a Netgear's modified version of kamikaze 7.09. Again, this is similar to the WNDR3700's which appears to natively run a fork of build 7.09.
Am I wrong to think the WNR2200 could therefore be supported? I'll pursue researching the development path over at openwrt.org. Thanks for the response!
Kamijaze is an old version of OpenWRT.
Gargoyle is based on backfire, which is the newest version of OpenWRT.