Page 1 of 1
[SOLVED]Cannot acces to the router
Posted: Sun Feb 12, 2012 7:26 am
by Nerus87
Hi, i have TL-WR1043ND, flashed to this version: "gargoyle_1.5.3-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin".
I cannot access to my router via www, but i can connect to the router and get in via ssh, WLAN is disabled.
How i can get to the www administration and run WLAN network ?
Re: Cannot acces to the router
Posted: Sun Feb 12, 2012 7:41 am
by Nerus87
Ok, problem solved, for connecting the router, use the HTTPS protocol.
To enable the WLAN, you must run it through a web panel.
Re: Cannot acces to the router
Posted: Sun Feb 12, 2012 7:43 am
by hnl_dk
Nerus87 wrote:Hi, i have TL-WR1043ND, flashed to this version: "gargoyle_1.5.3-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin".
I cannot access to my router via www, but i can connect to the router and get in via ssh, WLAN is disabled.
How i can get to the www administration and run WLAN network ?
I guess that you have nod32?
Disable that one and try to check if you are able to access your router now.
If that is working, do you need to whitelist the routers IP address, in nod32, so it does not block your access.
Re: Cannot acces to the router
Posted: Sun Feb 12, 2012 7:43 am
by hnl_dk
Nerus87 wrote:Ok, problem solved, for connecting the router, use the HTTPS protocol.
To enable the WLAN, you must run it through a web panel.
Sounds very much like a nod32 problem.
Re: [SOLVED]Cannot acces to the router
Posted: Sun Feb 12, 2012 7:52 am
by Nerus87
I turned off all modules of ESET 5, but i have the same problem.
I will use https - why not ?
Re: [SOLVED]Cannot acces to the router
Posted: Sun Feb 12, 2012 7:53 am
by hnl_dk
Nerus87 wrote:I turned off all modules of ESET 5, but i have the same problem.
http://kb.eset.com/esetkb/index?page=co ... d=SOLN2890