Re: Version 1.5.1 & 1.4.4
Posted: Tue Dec 13, 2011 12:05 pm
I upgrade my WR1043ND to 1.5.1 version and when I try to install nano, the router restarts. Sometimes it shows the message "Segmentation fault" and restarts.
A forum to discuss the Gargoyle web interface for Openwrt
https://www.gargoyle-router.com/phpbb/
Known problem, fix is on the wayalencarazevedo wrote:I upgrade my WR1043ND to 1.5.1 version and when I try to install nano, the router restarts. Sometimes it shows the message "Segmentation fault" and restarts.
Gargoyle 1.4.4 should work with your WRT160NLdcoomans wrote:Goodday, is Gargoyle 1.4.4 based on OpenWrt Backfire 10.03.1 RC6 ? or a newer build?
Planning to install it on my (also with stock latest firmware not so good performing) WRT160NL
Thanx in advance,
Dennis
Don't know it can helpTrailblazer wrote:Like the last version I had (v. 1.5), I have to reboot the routers every night with v. 1.4.4. The problem I'm having is a slowdown of the internet as reported by speedtest.net. It seems progressive, meaning the longer it goes on, the worse it gets. I've seen the 'problem' reduce my 20Mb line down to 1Mb. Reboot the router, problem solved. The problem is worse on the RSPro than it is on the Buffalo. RSPro takes one day for slowdown to occur, Buffalo took 4 days to see the problem.
I'm probably going back to the last version which worked flawlessly for me - v. 1.3.14.
Thanks again for the best firmware. I've completely abandoned DDWRT.
Thanks for your response. I use OpenDNS servers configured under 'Custom DNS Servers'. I don't know how to change dnsmasq. How?behappy wrote: Don't know it can help
- dns : use dns from yr provider, not local 127.0.0.1, change dnsmasq
- sysctl.conf: change the conntrack timeout
What version of WZR-HP-G300NH?yc3948 wrote:Version 1.5.1 Buffalo WZR-HP-G300NH will "dead" if power off or reboot!!! but can login to failsafe recover mode.
WZR-HP-G300NH I think only 1 version... how can I find the version info?DoesItMatter wrote:What version of WZR-HP-G300NH?yc3948 wrote:Version 1.5.1 Buffalo WZR-HP-G300NH will "dead" if power off or reboot!!! but can login to failsafe recover mode.
Did you just buy this recently? Or have you had it for a while?
http://wiki.openwrt.org/toh/buffalo/wzr-hp-g300h
There is an updated version with a newer switch that some people
have been having issues with OpenWRT / Gargoyle running on those.
It should have better support in future releases of OpenWRT/Gargoyle