Gargoyle Forum

Hello

I had Gargoyle working in my Fonera, but I wanted to try different firmwares(original fonera, DD-WRT and Open-WRT).
I have worked with all of them but now I can´t make gargoyle works again.
I use fonflash to charge it, I have sucesfully done process after updating firmware, but I don´t have web access to fonera.
It assign ip 192.168.1.1 to my ethernet card, I can make ping to it but I cannot access trought web.

Only power and computer leds are on, please any suggestion?

Thank you in advance.

Can you get in via Redboot?

If you can - full format the data part with the command

fis init -f

Then re-flash Gargoyle 1.2.5 on there to make sure it works properly

You should NOT be getting assigned an address of 192.168.1.1

It should be 192.168.1.2+

Oh sorry, I´m wrong.
Fonera IP is correct, it have 192.168.1.1. IP
Ethernet card have 192.168.1.105, this is in windows, with dhcp activated.
I make redboot and apply fis format -f, then reflash gargoyle with fonflash and the same result: only power and computer led on.
Any suggestion?

Thank you.