A forum to discuss the Gargoyle web interface for Openwrt
https://www.gargoyle-router.com/phpbb/
Code: Select all
http://www.gargoyle-router.com/packages/gargoyle-1.16/ath79/defaultIn the same folder as you downloaded the image from, as per the first post.ektus wrote: ↑Wed Apr 03, 2024 4:47 amJust installed it on my spare Archer C7 V2. Seems to be running just fine without further configuration. Wifi untested.
Where to point the plugin source? Default iswhich doesn't seem to be populated yet.Code: Select all
http://www.gargoyle-router.com/packages/gargoyle-1.16/ath79/default
Code: Select all
https://lantisproject.com/gargoyle_custom/1.15.x_2305_test_builds/ath79/default/
https://lantisproject.com/gargoyle_custom/1.15.x_2305_test_builds/ath79/default_kernelspecific/
It was also showing partition change warning - i put the factory image in /tmp and did:JohnPeterson wrote: ↑Wed Mar 13, 2024 10:51 amI see the Linksys WRT1900ACS is avail again. I get screen message when attempting an upgrade.
Firmware/Device Compatibile:No. Config cannot be migrated from swconfig to DSA
Thanks.
Tested usteer and it works between 2.4G and 5G for the same SSID within a wireless router e.g. WRT3200ACM vs iPhones. Looking forward to seeing the official 1.15.Lantis wrote: ↑Tue Mar 26, 2024 5:47 amThe usteer package is installed by default on most profiles, others will need to install it.
There is no GUI configuration for usteer except for being able to turn it on and off to help send AP client information between multiple Gargoyle routers on the same network (in a multi-AP setup for example).
Search for usteer for OpenWrt and read about the configuration. The default should work for most people but your mileage may vary!
If you wanted to try DAWN instead you can but you’ll need to install that and try it.
Fantastic.angus wrote: ↑Sat Apr 06, 2024 3:22 amTested usteer and it works between 2.4G and 5G for the same SSID within a wireless router e.g. WRT3200ACM vs iPhones. Looking forward to seeing the official 1.15.Lantis wrote: ↑Tue Mar 26, 2024 5:47 amThe usteer package is installed by default on most profiles, others will need to install it.
There is no GUI configuration for usteer except for being able to turn it on and off to help send AP client information between multiple Gargoyle routers on the same network (in a multi-AP setup for example).
Search for usteer for OpenWrt and read about the configuration. The default should work for most people but your mileage may vary!
If you wanted to try DAWN instead you can but you’ll need to install that and try it.
P.S. I did enable the Fast Roaming. Thought that may not be required.
https://openwrt.org/docs/guide-user/network/wifi/usteerTested usteer and it works between 2.4G and 5G for the same SSID within a wireless router e.g. WRT3200ACM vs iPhones. Looking forward to seeing the official 1.15.
P.S. I did enable the Fast Roaming. Thought that may not be required.
