Gargoyle Forum

Hello all,

Can someone help me with an image for the GL-MT6000?

https://openwrt.org/toh/hwdata/gl.inet/ ... _gl-mt6000

That device is only supported by Snapshot, so no we can’t do that in Gargoyle (yet).
Once it is part of a release perhaps.

It appears to have been back ported into 23.05 after 23.05.2, so possibly a little closer to being supportable in Gargoyle than if it were only in main snapshots.

Hello Lantis,
I see that you have compiled firmware for GL-MT6000, what is the installation procedure for gargoyle if you switch from the original firmware or from openwrt to Gargoyle?

https://lantisproject.com/gargoyle_cust ... /mediatek/

I installed gargoyle on GL-MT6000, INTERNET 1Gbps, in the speed test on the wire it does not exceed 500Mbps Download and Uploud 890Mbps, Connect Via:PPPOE ipv6 dual stack, that's all Gargoyle is capable of, there are some incompatibilities?

Disable Bandwidth Monitor, I reach up to 890/908 Mbps download and 880/923 upload

/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable

What is gargoyle installation procedure for the router? Should I flash 'factory' or 'sysupgrade'?

I always thought that for upgrading from Gargoyle/OpenWRT I have to use 'sysupgrade'.

If so, why 'factory' is provided as the MT6000 is OpenWRT based?

Thanks.

You can just sysupgrade for that device.
The factory image is available for those that want to get rid of the GLiNet uboot. I personally feel that it should be kept as the benefits outweigh any perceived risks.

Thanks.
Flashed sysupgrade, no issues yet. Manually copy settings from old router...