Page 1 of 1
Support GL-MT6000
Posted: Tue Dec 26, 2023 1:25 pm
by oliver44
Hello all,
Can someone help me with an image for the GL-MT6000?
https://openwrt.org/toh/hwdata/gl.inet/ ... _gl-mt6000
Re: Support GL-MT6000
Posted: Tue Dec 26, 2023 6:07 pm
by Lantis
That device is only supported by Snapshot, so no we can’t do that in Gargoyle (yet).
Once it is part of a release perhaps.
Re: Support GL-MT6000
Posted: Wed Dec 27, 2023 5:37 am
by pythonic
It appears to have been back ported into 23.05 after 23.05.2, so possibly a little closer to being supportable in Gargoyle than if it were only in main snapshots.
Re: Support GL-MT6000
Posted: Mon Mar 11, 2024 11:36 am
by oliver44
Hello Lantis,
I see that you have compiled firmware for GL-MT6000, what is the installation procedure for gargoyle if you switch from the original firmware or from openwrt to Gargoyle?
https://lantisproject.com/gargoyle_cust ... /mediatek/
Re: Support GL-MT6000
Posted: Mon Mar 11, 2024 12:34 pm
by oliver44
I installed gargoyle on GL-MT6000, INTERNET 1Gbps, in the speed test on the wire it does not exceed 500Mbps Download and Uploud 890Mbps, Connect Via:PPPOE ipv6 dual stack, that's all Gargoyle is capable of, there are some incompatibilities?
Re: Support GL-MT6000
Posted: Mon Mar 11, 2024 12:44 pm
by oliver44
Disable Bandwidth Monitor, I reach up to 890/908 Mbps download and 880/923 upload
/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable