Archer c6 - storage full error
Posted: Wed Dec 28, 2022 3:57 pm
Hello.
I have TP-Link Archer C6 v2. There is the same error with small Flash memory as described here in the post: "Archer C60 storage full error" in this forum.
The router writes Storage Full Error in its web interface.
I downloaded sources of Gargoyle 1.13, change config file according to the post: "Problems with building an image"
and the problem persisted, so I again used menuconfig and clear another options like video for linux...more USB drivers, etc..then the firmware finaly fit into the memory, the error message dissapered.....
...but the firmware is broken, some buttons ond option in web interface are marked as "unknown", some buttons does not work (does nothing). Picture in attachment.
When I load "factory" firmware into the router via TFTP, I see this "unknown" buttons. When I load "sysupgrade" firmware via web interface, I see nowmal correct buttons, but there is the "storage full message". Both firmwares factory and sysupgrade are from the same build....so it should not be badly configured. It seems that when firmware fits into the memory, but on its upper boundary, the languages or some texts are shown badly.
"factory" has 7 572 114 B
"sysupgrade" has 7 602 969 B
Config file is also in attachment.
Any advice what to do in config file to get proper fw for Archer c6 v2? Maybe clear more options to get more free space in memory...? I don't know.
Thank you.
Ondrej
I have TP-Link Archer C6 v2. There is the same error with small Flash memory as described here in the post: "Archer C60 storage full error" in this forum.
The router writes Storage Full Error in its web interface.
I downloaded sources of Gargoyle 1.13, change config file according to the post: "Problems with building an image"
and the problem persisted, so I again used menuconfig and clear another options like video for linux...more USB drivers, etc..then the firmware finaly fit into the memory, the error message dissapered.....
...but the firmware is broken, some buttons ond option in web interface are marked as "unknown", some buttons does not work (does nothing). Picture in attachment.
When I load "factory" firmware into the router via TFTP, I see this "unknown" buttons. When I load "sysupgrade" firmware via web interface, I see nowmal correct buttons, but there is the "storage full message". Both firmwares factory and sysupgrade are from the same build....so it should not be badly configured. It seems that when firmware fits into the memory, but on its upper boundary, the languages or some texts are shown badly.
"factory" has 7 572 114 B
"sysupgrade" has 7 602 969 B
Config file is also in attachment.
Any advice what to do in config file to get proper fw for Archer c6 v2? Maybe clear more options to get more free space in memory...? I don't know.
Thank you.
Ondrej