Page 1 of 1
Buffalo WHR HP G300N
Posted: Tue May 31, 2011 9:22 am
by nchall
Hi. This is a Atheros AR7240 chip with 32 MB Ram. Would it be possible to run Gargoyle on it? I'm trying to avoid DD-WRT and the stock firmware as they have limitations.
Re: Buffalo WHR HP G300N
Posted: Tue May 31, 2011 12:15 pm
by DoesItMatter
http://wiki.openwrt.org/toh/buffalo/start
Those are the current officially supported routers from Buffalo
Once OpenWRT supports a router, Gargoyle will usually
support it within the next 1 or 2 builds, depending when Eric
refreshes and updates to the current OpenWRT builds.
Might find more info in the OpenWRT forums on whether or not
this is a work-in-progress for the WHR-HP-G300N
Re: Buffalo WHR HP G300N
Posted: Sat Dec 17, 2011 3:46 am
by nchall
Anyone have any more ideas about getting OpenWRT or Gargoyle running on this?
Re: Buffalo WHR HP G300N
Posted: Wed Jan 25, 2012 1:07 pm
by nchall
I now have OpenWrt running on this router using a trunk build and now just need to figure out how to install Gargoyle on it. Any ideas?
Re: Buffalo WHR HP G300N
Posted: Sat Mar 31, 2012 4:29 am
by nchall
So no ideas on this? Supported in trunk here:
http://wiki.openwrt.org/toh/start#buffalo
Re: Buffalo WHR HP G300N
Posted: Sat Mar 31, 2012 2:02 pm
by mix
No idea.
Re: Buffalo WHR HP G300N
Posted: Sat Mar 31, 2012 5:14 pm
by DoesItMatter
Gargoyle only works with official releases from OpenWRT (Backfire)
Trunk would require a LOT of editing of the source as quite a few
things have changed.
If you need to use OpenWRT Trunk - you're stuck with OpenWRT for now
Re: Buffalo WHR HP G300N
Posted: Sat Mar 31, 2012 7:56 pm
by nchall
Ok thanks. Will post back when/if it becomes official.
Re: Buffalo WHR HP G300N
Posted: Thu Jun 06, 2013 5:15 am
by uggla
This router has been in the openwrt trunk since (at least) January does that mean it should work with the latest Gargoyle?
Re: Buffalo WHR HP G300N
Posted: Thu Jun 06, 2013 11:13 am
by DoesItMatter
It's reported as supported by the trunk versions which means
newer than Attitude Adjustment 12.09 official / Gargoyle 1.5.10
Don't flash Gargoyle on these yet - need to wait a bit
I used to have a WHR-HP-G300N but put it in use in a business office
It's running one of the trunk builds of Barrier Breaker
This is a fantastic router for range/signal/multiple wireless clients
Not supported by Gargoyle 1.5.10 though.