Gateway not working as assign
Posted: Sun May 09, 2021 7:57 pm
Hello everyone,
I have perform a Firmware upgrade to a TL-WR1043ND V1 which I did use Firmware gargoyle_1.12.0-ar71xx-generic-tl-wr1043nd-v1-squashfs-sysupgrade.bin
I am using this router as an Access Point connected with an Ethernet cable
My settings network address are:
Static IP: 10.0.0.4
Subnet Mask: 255.255.255.0
Gateway: 10.0.0.1
When I am connected with Ethernet or Wifi Ipconfig shows as this example:
IP: 10.0.0.120
Subnet Mask: 255.255.255.0
Gateway: 10.0.0.4 instead of 10.0.0.1
I do not understand why when I am connected to this Gargoyle Firmware Router , The Gateway of my Ethernet or Wifi Card are set to 10.0.0.4 . This is affecting all my Entire Network with other Router or access point in line.
Is there someone who can help me please?
I have perform a Firmware upgrade to a TL-WR1043ND V1 which I did use Firmware gargoyle_1.12.0-ar71xx-generic-tl-wr1043nd-v1-squashfs-sysupgrade.bin
I am using this router as an Access Point connected with an Ethernet cable
My settings network address are:
Static IP: 10.0.0.4
Subnet Mask: 255.255.255.0
Gateway: 10.0.0.1
When I am connected with Ethernet or Wifi Ipconfig shows as this example:
IP: 10.0.0.120
Subnet Mask: 255.255.255.0
Gateway: 10.0.0.4 instead of 10.0.0.1
I do not understand why when I am connected to this Gargoyle Firmware Router , The Gateway of my Ethernet or Wifi Card are set to 10.0.0.4 . This is affecting all my Entire Network with other Router or access point in line.
Is there someone who can help me please?