"LAN DHCP Server Enabled" selection not persistent
Posted: Thu Aug 20, 2020 2:40 am
Every time I make any settings change, the gargoyle LAN-DHCP re-enables its self and all my client connections slow to a crawl or just fail to resolve entirely, both LAN and WAN traffic.
I already have a DHCP server on my file server(along with local DNS) so I do not want DHCP server enabled on the gargoyle router.(This is so I don't need to reconfigure tons of reserved addresses every time I switch to a new router.)
This is not a show stopper as long as I remember to finish every router admin session with a stop on the Connection>DHCP page, but it is a source of frustrating network mystery-problems just the same.
Gargoyle Version:1.12.0
Model:Linksys WRT1900ACS
Device Configuration:Gateway
Memory Usage:48.6MB / 498.9MB (9.7%)
Connections:97/4096
Other than this ...bug, or undocumented feature? Gargoyle has been a very nice product, much better than my prior factory-hobbled routers.
I already have a DHCP server on my file server(along with local DNS) so I do not want DHCP server enabled on the gargoyle router.(This is so I don't need to reconfigure tons of reserved addresses every time I switch to a new router.)
This is not a show stopper as long as I remember to finish every router admin session with a stop on the Connection>DHCP page, but it is a source of frustrating network mystery-problems just the same.
Gargoyle Version:1.12.0
Model:Linksys WRT1900ACS
Device Configuration:Gateway
Memory Usage:48.6MB / 498.9MB (9.7%)
Connections:97/4096
Other than this ...bug, or undocumented feature? Gargoyle has been a very nice product, much better than my prior factory-hobbled routers.