Gargoyle Forum

I have a att DSL connection (1.5 , 0.256) that I normally have my router manage the PPPoE for years my setup worked fine but DD-WRT builds this year for me had no wlan connection at all so I came to try Gargoyle again .
I set up PPPoE and all look ok until I start something like a game , YouTube , Facebook or windows update.
Doing nothing and it holds a uptime over 45minutes but them moment I do anything more then just a simple webpage it disconnects .
Am I missions something ?

What version of gargoyle?

ispyisail wrote: ↑

Fri Jul 03, 2020 1:35 am

What version of gargoyle?

1.12 stable

If my memory is correct I had the same issue last time I tried to use gargoyle for my main router when 1.6.2 first came out.

You could try 1.12.x which is actually more stable than "1.12 stable"

viewtopic.php?f=14&t=12458

Don't use a backup file or try preserving setting on upgrade.

I installed OpenWrt 19.07.3 on my main router to see if it was a gargoyle problem only or a OpenWrt problem and found out OpenWrt has the same problem keeping a connection .
I made a post on the OpenWrt forms and hopefully will have a solution soon .

https://forum.openwrt.org/t/pppoe-keeps ... ng/68743/1

Thanks for the update

Try "Force Link" in the WAN interface settings. It helped me.

Gargoyle:
a) Edit the /etc/config/network file and add the option to the WAN Interface: b) To be sure, you can still delete the modem access file by running the command - it helped me too: LuCI in OpenWrt:

Force Link helped some but I still lost connection .

If I could find the info about the speed of the pppoe on openwrt I could make sure it is requesting the right speed.

Paste here, your modem DSL stats.

I have AT&T FastAccess DSL Ultra
1.5 - 0.256


http://att.net/speedtiers