Gargoyle Forum

When I set gargoyle as Client+AP, I can not connect to a AP with MAC filter or hidden SSID. If I disable MAC filter or show SSID, then Client mode can connect to the AP.

I have no problem connecting to AP with WPA. But I want to save some cpu processing by disabling the encryptions.

I have tried firmware 1.2.5, 1.3.10 and 1.3.11.

Is there any settings I missed?

My bad.

I was looking at the MAC address on the Gargoyle GUI.

The actual MAC address detected by the AP is different to GUI.

All good now.