Gargoyle Forum

USE AT YOUR OWN RISK

WARNING: DO NOT PRESERVE SETTINGS

Now includes packages

Do not install on 4MB routers

1.11.x

gargoyle-ispy 2018-April-24 21:48
https://goo.gl/PbwaHN

magnet:?xt=urn:btih:0ab2510f2ac50a4d361f6f0879f83acb0f3d9a68&dn=gargoyle-ispy%202018-April-24%2021_48.7z&tr=udp%3a%2f%2ftracker.openbittorrent.com%3a80&tr=udp%3a%2f%2fopen.demonii.com%3a1337&tr=udp%3a%2f%2ftracker.coppersurfer.tk%3a6969&tr=udp%3a%2f%2ftracker.leechers-paradise.org%3a6969&tr=udp%3a%2f%2ftracker.coppersurfer.tk%3a6969%2fannounce&tr=udp%3a%2f%2ftracker.open-internet.nl%3a6969%2fannounce&tr=udp%3a%2f%2fallesanddro.de%3a1337%2fannounce&tr=udp%3a%2f%2f9.rarbg.to%3a2710%2fannounce


Routers
https://goo.gl/sqqqn6

I've just realized that I haven't build mvebu images

I wouldn't just yet. They're boot loop city.

Flashed a tl-wdr4300 v1.6.
I preserved settings from (Built 20180416-1938 git@1e8055c) and all is good it seems. Only afterwards I see your warning about preserving settings. Maybe it is only relevant when changing from 1.10 to 1.11.X ?

Maybe it is only relevant when changing from 1.10 to 1.11.X ?

I suspect most people do....

I just cut and paste...

flashed the following
wndrmacv2 and wndr3800 with no issues
wndr3700v4 and wndr4300v1 only issue was that 5 ghz wasn't detected after 30 sec wait and reboot 5 ghz shows up

thanks for your update

anyone else having really bad performances with this build ?
Archer C7 and Wdr3600.

phgerin wrote:anyone else having really bad performances with this build ?
Archer C7 and Wdr3600.

more details?

Cpu load is low on archer C7, but I can't get more than 10 Mbits on a 100Mbits line. Previous build was ok(up to 85 Mbits).
Computer connected on Ethernet.
Same config...

Is qos enabled and set to the right value?

Qos enabled, default settings, bandwidth adjusted in QOS settings.
I'll try to reset everything