Page 2 of 3
Re: Bridge Mode - How to do it right
Posted: Sun Apr 01, 2018 9:13 am
by SpudMuffin
OK, yes... I am viewing the upsteam router's DHCP client list and there is no IP listed, however, the gargoyle AP is working, but I can't access the gargoyle??
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 8:54 am
by SpudMuffin
What do I need to do to access my gargyle now that I have it operating as you suggested?
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 9:15 am
by Lantis
If your upstream is not showing it as a client then what static IP did you set for it?
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 1:36 pm
by SpudMuffin
I only changed those things that you mentioned. However, over to the right on the config panel was 192.168.1.1,255.255.255.0,192.168.1.1... tried that but no success either..
Since I did a full reset, is there a default?
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 2:28 pm
by ispyisail
screen shots would be very helpfull
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 8:01 pm
by SpudMuffin
Yes, but I can't access GUI so can't get SS....
Re: Bridge Mode - How to do it right
Posted: Mon Apr 02, 2018 8:43 pm
by ispyisail
failsafe reset and start again
Re: Bridge Mode - How to do it right
Posted: Tue Apr 03, 2018 8:22 am
by SpudMuffin
How do I set static IP? or choose DHCP?
Re: Bridge Mode - How to do it right
Posted: Tue Apr 03, 2018 8:33 am
by Lantis
When you set connect via to disabled you can enter an IP address for the router.
Re: Bridge Mode - How to do it right
Posted: Tue Apr 03, 2018 10:26 am
by SpudMuffin
Does it have to be the same subnet? If so, that is where I made my mistake earlier....