Gargoyle Forum

I installed Gargoyle on my TP-Link AC1750 (archer c7) and it was working great. However, I thought I would like to try it in AP mode... On the Gargyle GUI AP/Bridge page I disabled repeater mode and for the top 2 Bridge IPs I put my primary router's IP 192.168.0.1 and for the second entry /Gateway I put 192.168.1.1

I have no wireless signal now but anything I plug into the Gargoyle router gets a 192.168.0.x IP from the primary router... I looked on the primary router DHCP to see what the gargoyle IP was and there is nothing?!?!? I have tried numerous IPs while connected to the gargoyle but the only GUI I get is from the primary router....

I tried doing a reset with the reset button on the back, but apparently that doesn't work with gargoyle?!?!? what can I do?

google failsafe reset

also there has been a change to the failsafe reset procedure between gargoyle versions.

1.10.x uses SSH instead of telnet

or something to that effect

OK, got the GUI to work... but no wifi signal for the AP....

Share your settings with us and I’m sure we’ll get you headed in the right direction.
Post some screenshots to an external site and link here.

shared in other "wireless" thread