Page 1 of 1
1.3.10 Nanostation2 Settings lost everytime
Posted: Tue Feb 22, 2011 8:34 am
by scalawag
Hi.
I installed 1.3.10 on my Nanostation2 but it seems it doesn't save the settings anymore
I have to manually configure it on every reboot or powerdown.
1.3.9 worked fine.
PS: I didn't upgrade from 1.3.9 to 1.3.10. I did a fresh install with tftp.
Re: 1.3.10 Nanostation2 Settings lost everytime
Posted: Fri Feb 25, 2011 3:18 am
by DoesItMatter
UBIQUITI NANOSTATION LOCO2 WIRELESS CPE OUTDOOR 8DBI DUAL-POL 802.11b/g
NanoStation Loco provides a breakthrough in cost, reliability, performance. Features up to 10km of range performance, 25+Mbps of throughput performance, & the powerful, intuitive AirOS by Ubiquiti. NanoStation Loco is the latest innovation in broadband wireless CPE technology from Ubiquiti.
Features Include:
Processor Specs: Atheros MIPS 4 KC, 180MHz
Memory Information: 16MB SDRAM, 4MB Flash
Networking Interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
Approvals: FCC Part 15.247, IC RS210, CE
----------------------
Also see this thread:
http://www.gargoyle-router.com/phpbb/vi ... 1133#p5442
I think these 4MB flash / 16MB ram routers are just too small