Gargoyle Forum

First off, I'd like to thank the developers for a truly open-sourced firmware, not a shareware, pay-for-the-pro-version deal. I flashed a Linksys WRT54G V3.1 with Gargoyle and am very pleased with the results. To be frank, it puts DD-WRT to shame.

Here's my question...I read on this forum that Linksys WRT350n v1 routers have been successfully used with Gargoyle, and I read on the OpenWRT wiki that OpenWRT is compatible with the WRT350n v2, but I was curious - has anyone ever tried putting Gargoyle on a WRT350n v2 before?

If not, should I be prepared for any special cases or possible failures and the subsequent recovery?

Okay, I got the router and went to the OpenWRT site to get an image for Kamikaze...but all I could find was a link to a repository of binaries with no documentation whatsoever. I tried to get the source code to compile it myself, but I ran into some oddball issues with that as well.

I hate to sound like a noob, but is it possible someone could please help me with getting a Gargoyle image for a WRT350n V2?

http://wiki.openwrt.org/toh/linksys/wrt350nv2

Check that, updated as of 2/14/11

Looks like its still a work-in-progress

Might be a wait for full support for it.

I would NOT flash Gargoyle on it - or try to.

Once it gets fully supported by OpenWRT - it should be
supported by Gargoyle sometime after that.

Thank you, that was the page I couldn't find...although they've changed it a lot since I last saw it.

Looks like I'll just hang in there till things get fixed up a bit then, thanks!