From Gargoyle to LEDE
Posted: Thu Sep 21, 2017 7:45 am
Should I use the factory bin file first or can I just flash the sysupgrade bin file directly?
Gargoyle Forum
A forum to discuss the Gargoyle web interface for Openwrt
https://www.gargoyle-router.com/phpbb/
From Gargoyle to LEDE
Page 1 of 1
Re: From Gargoyle to LEDE
Posted: Thu Sep 21, 2017 12:47 pm
I used the sysupgrade bin file through the gargoyle firmware upgrade page and it worked fine for me.
Re: From Gargoyle to LEDE
Posted: Thu Sep 21, 2017 1:08 pm
Sysupgrade.bin file will work just fine.
Re: From Gargoyle to LEDE
Posted: Thu Sep 21, 2017 1:14 pm
Appreciate the help, but I can't make it to work so I went back to Gargoyle. 
Re: From Gargoyle to LEDE
Posted: Thu Sep 21, 2017 3:13 pm
Even better. 
Was there a specific feature in LEDE that you were after ?
Was there a specific feature in LEDE that you were after ?
Re: From Gargoyle to LEDE
Posted: Sat Sep 23, 2017 1:20 am
I was trying to check it's SQM feature but unfortunately I don't know how to make it work as I'm not that tech-savvy with networking. Unlike Gargoyle, I can just choose DHCP wired from the drop-down menu and connect the router to my modem which is in bridge mode.d3fz wrote:Even better.
Was there a specific feature in LEDE that you were after ?